BC Coat RBE 100

Description:

Polycoat RBE 1000 is an emulsified bituminous coating modified with high content of Styrene Butadiene Styrene rubber, which dries to form a tough and seamless, flexible water and vapor proof protective coating

application instructions:

Application procedures may vary slightly depending upon site conditions

The general recommended guideline for the application of the bitumen coating system is as follows:

Coverage:

. The coating shall be applied at a coverage rate of l-2m2/ L/coat at required no. of coats and may vary depending on the requirement

It is highly recommended to apply a priming coat prior to the application of the BC coat RBE 100 coating on the substrate

For very dry and porous substrates apply two coats of this primer

The primer can be applied to damp or freshly cast concrete surfaces also.

However, it should not be applied on waterlogged or flowing water areas

in case of delay in application of thetop coat formore than 24 hours, a fresh coat of primer

shall be re-applied.

Foundation Waterproofing

Stir the contents of the drum thoroughly before application to remove all sediments

Packaging:

200 kg